Table of Contents
Advertisement
Sonix Hmi-Tu Technical Manual
1 Introduction
These instructions are intended for all users who
have to install, commission, configure and setup the
Sonix Hmi-Tu access panel interface unit. For this, the
manual is action-oriented and explains how to achieve a
certain objective on a step-by-step basis. It is assumed
that you have necessary electrical, electronic and
telecommunications experience to undertake the work.
If in doubt, please consult your Eaton representative.
1.1 Eaton quality assurance
Eaton design, manufacture, install and commissions all
our products to the highest standards of quality. This
quality process is embraced and adopted throughout the
group in all areas of our operations. This is demonstrated
by our compliance and strict adherence to ISO 9001,
14001, ATEX and IECEX policies. On receipt of the
product, ensure that the cartons are undamaged and
that the contents are all correct and complete. Should
this product reach you in an unsatisfactory condition
please report this to Eaton to enable us to rectify and
investigate the fault in a speedy manner.
1.2 Packaging
In the interest of preserving the environment, Eaton aims
to use recycled packaging wherever practical. Due to the
physical nature of our products, we provide adequate
packaging to protect the goods during transit. Please
ensure that once unpacked, checked and installed that
all packaging is disposed of or recycled in a responsible
manner.
1.3 ESD (Electro Static Discharge)
The Sonix PA/GA system is largely constructed from
electronic printed circuit boards. These printed circuit
boards are sensitive to static electricity, ESD discharge
on any Eaton products could cause permanent and
irreparable damage to the equipment. All such PCB's
are shipped to you in ESD protective bags for transit.
Prior to opening the transit bags please ensure that you
are wearing either an ESD, earthed wrist strap or other
suitable means of protection.
1.4 Safe working practice
Whilst working on or within the Sonix PA/GA system it
is our prime interest that you remain safe throughout.
During this work you may be exposed to potentially
hazardous voltages, currents, confined spaces and
potentially industrial environments.
Prior to undertaking any work please ensure relevant
permits and regulations are adhered to.
6
SONIX HMI-TU TECHNICAL MANUAL TM377 / A June 2022 www.eaton.com
1.5 Required tools
To install and commission this part you will need the
following tools.
Flat-blade terminal screw driver
•
Small Flat-blade terminal screw driver up to 2.5 mm
•
Multi-meter
•
1.6 In the box
This item is shipped with the following items.
1 x Hmi-Tu
•
1 x Product Manual
•
1.7 Recommended spares
This item is sold as a complete module. It is
recommended the following fuses are kept as spares:
Fuse
Mute outputs
Access panel Port 1 - 4
Rating
Anti-surge T160mA
Anti-surge T500mA (1 per port)
Advertisement
Table of Contents
