Fitting The Cutting Blade - Stihl FC 83 Instruction Manual

Fitting the Cutting Blade

1
:
Place the power edger on a
suitable support so that the blade
mounting (1) faces upwards.
FC 83
5
6
4
3
:
Insert the Allen wrench (2) as far as
possible in the bore (3) – push
lightly and rotate it back and forth
together with the thrust washer (4)
until the drive shaft is blocked.
:
Apply combination wrench (5) to
screw (6).
:
Loosen screw clockwise (left-hand
thread) and take it out.
: Remove retaining ring, plain washer
and thrust washer.
7
11
7
2
:
Position blade (7) on the thrust
plate (8).
Collar (see arrow) must engage
hole in blade!
: Fit thrust washer (4) on the drive
shaft (9).
: Block the drive shaft.
:
Insert screw (12) with plain washer
(10) and retaining ring (11) in shaft
counterclockwise and tighten down
firmly.
english / USA
12
10
4
9
8
15