Air Recirculation - Danby DOM014401G1 Installation Manual

INSTALLATION INSTRUCTIONS - RECIRCULATING (NON-VENTED)
Install grease fi lters
Slide the grease fi lters into the openings in the bottom of the microwave until they click into place. The
appliance should not be operated without the grease fi lters installed.

Air recirculation

There is no duct work required for this type of installation. Air from the appliance will exhaust through the
front vent and recirculate into the air in the room.
Charcoal fi lter
The charcoal fi lter should be used in non-vented,
recirculating installations. The fi lter should be
changed every 6 to 12 months depending on use.
1. Remove the two screws securing the louver on
the front of the microwave.
2. Remove the used charcoal fi lter.
3. Install the new charcoal fi lter. The wire mesh of
the fi lter should be visible from the front.
4. Reinstall the louver.
To purchase replacement fi lters, either contact the
consumer service department or visit
www.DanbyApplianceParts.com or
www.DanbyApplianceParts.ca
22