IDEC SE4D Series Quick Instruction Manual page 36

<Mounting of the bottom cap cable (optional)>
● Do not lose any screws during extension / dismantling.
● Connect the cable to emitter and receiver without fail using their colors as the guide.
1. Insert the connector of the bottom cap cable (optional) into the connector of this device.
When inserting the connector, fit the cable to the groove of this device.
2. Tighten the two M2.6 screws. The tightening torque should be 0.3N·m or less.
36
CAUTION
Bottom cap cable (Optional)
Connector
Cable
Connector
Groove
This device
M2 6 screw
Enclosed with the
bottom cap cable