Confirmation Of Packed Contents - IDEC SE4D Series Quick Instruction Manual

♦ Maintenance
• When replacement parts are required, always use only genuine supplied replace-
ment parts. If substitute parts from another manufacturer are used, the device may
not come to detect, result in death or serious injury.
• The periodical inspection of this device must be performed by an engineer having the
special knowledge.
• After maintenance or adjustment, and before starting operation, test this device fol-
lowing the procedure specified in "10. Maintenance."
• Clean this device with a clean cloth. Do not use any volatile chemicals.
♦ Others
• Never modify this device. Modification may cause the device not to detect, resulting
in death or serious injury.
• Do not use this device to detect objects flying over the sensing area.
• Do not use this device to detect transparent objects, translucent objects or objects
smaller than the specified minimum sensing objects.

2. Confirmation of Packed Contents

□ Sensor: Emitter, Receiver
□ Test rod: SE9Z-TR25 (ø25 × 220mm)
□ Intermediate Supporting Bracket SE9Z-SED-2
Note: The intermediate support bracket SE9Z-SED-2 is enclosed with the following devices. The quan ity differs
depending on the device as shown below:
Set
1 set 40 to 56 beam channels
2 sets 64 to 80 beam channels
3 sets 88 to 96 beam channels
□ Quick Instruction Manual
□ CD-ROM (Instruction Manual: PDF format)
WARNING
Model No.
1 pc. each
1 pc
0 to 3 sets
1 pc.
1 pc.
31