Advertisement
ASSEMBLING THE ROBOT
If you assembled the rover first, you must first reverse
the steps 1-9 from the previous section (pages 17 and 18).
to unscrew the front wheels, you must first remove
the wheel caps. to do this, use the screwdriver to push on
1
assembly
3
Sensor assembly
5
the tabs of the wheel caps as shown to the right.
Chassis
with drive
180
Battery
Control unit
Assembling the Robot
T1
180
Right
arm
2
Control
unit
Slide the control unit into the chassis rail as
far as it will go. Make sure that the connection
strip is pointing toward the arms.
4
Connector
Head
assembly
To mount the connector on the head
assembly, push the two tabs together
and position the connector between the
two supports as shown. Then let the tabs
snap back.
6
L4
Repeat the step for the
left arm.
21
Advertisement
