Advertisement
CONTROL UNIT (F)
Apply the sticker to the rear housing
1
cover (F2) as shown.
F2
F3
3
Plug the speaker cable into the socket on the top right edge of the main board — this only
works in one direction, so if it does not fit at first, find the correct orientation.
5
F2
U2
F4
4
F2
Building the Subassemblies
F1
U2
Attach the
sticker to the
2
speaker cable as shown.
Position the main board (F6) on the
housing cover as shown and tightly
fasten it with two screws.
F6
Be careful not to damage any components
on the board while screwing it in.
F1
Then use four screws to
attach the speaker with
housing (F1) to the rear
housing cover (F2).
T1 (4x)
T1 (2x)
11
Advertisement
