Advertisement
ASSEMBLING THE ROVER
Before attaching the connector to the head
assembly, lay the infrared sensor cable down flat
across the underside of the head as shown.
6
Head assembly
with connector
Sensor assembly
Slide the head assembly onto the rail
of the chassis as far as it will go. Make
sure that the narrow part of the head
assembly faces forward. (The wires
7
are not shown.)
Slide the control unit into the
rail as far as it will go. Make
9
sure that the ports of the control
unit are facing outward.
18
Connector
Head
assembly
Push in
To mount the connector to the
head assembly, push the two
tabs together, and position the
connector between the two
supports as shown. Then let the
tabs snap outward.
Arrange the
sensor and head
assembly cables
as shown.
8
Connect the cables to the
control unit as follows:
Motor,
LED
Sensor
right
10
F
Connector
Push in
Head
assembly
Control unit
Motor,
Battery
left
Richtig
Done
Advertisement
