Maintenance And Servicing; Maintenance Of The Machine - Norton Clipper CT 901 HP Operating Instructions Manual

VERS. 2017.11.21

6 MAINTENANCE AND SERVICING

6.1 Maintenance of the machine

To ensure a long-term quality from the use of the CT901HP, please follow the maintenance plan
below:
Whole machine
Surface of blades or plate
Tension of the blade
Engine housing
Reachable nuts and screws
Maintenance of the machine
Always perform the maintenance with the machine switched off and the tools idle.
Lubrication
The
uses life-lubricated bearings. Therefore, you don't need to lubricate the machine at all.
Control and change of the belt
To control the tension of belts, open the belt guard, and push on the belts. You should be able to
gape the belt as thick as a finger. If the tension is incorrect, adjust the belt tension by stalling the
engine. Make sure that the pulleys are aligned before tightening the mounting nuts from the engine.
To change the belt, open the housing, remove the old belt and install a new on the pulleys.
Make sure that the pulleys are aligned before tightening the mounting nuts from the engine. After
the control or change the belts, always reassemble the belt guard.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work, especially engine and
blades or pan.
Others maintenance:
Please refer to the motor operating instructions or contact the motor service centre.
Visual control (general aspect,
water tightness)
Clean
Clean
Check
Clean
Tighten up
CT901HP_MAN_EN
16