Assembly And Commissioning; Handle; Tool Assembly - Norton Clipper CT 901 HP Operating Instructions Manual

VERS. 2017.11.21 CT901HP_MAN_EN

3 ASSEMBLY AND COMMISSIONING

The machine is delivered fully equipped. It is ready for operation after assembly of the tool and
adjustment of the machine arm, and after connection to the appropriate power supply.

3.1 Handle

Set the machine arm in a comfortable position. To that purpose, loosen the handle on the arm and
set the arm at the right angle, then retighten the handle.

3.2 Tool assembly

Only NORTON blades or plate with a maximum diameter of 900 mm can be used with the CT901
HP.
Before mounting a new tool into the machine, switch off the machine and make sure the tools are
not rotating anymore.
Screw 2 M6-screws per blade using a 10mm wrench to assemble the blade on the arm. To
assemble a plate, place the machine with the blades assembled on the plate, and turn it until the
blades are located in the hooks on the plate.
12