Bosch Climate 5000 Series Installation Instructions Manual page 16

Installation Instructions
MINIMUM BEND RADIUS
Carefully bend the tubing in the middle according to the diagram below.
DO NOT bend the tubing more than 90° or more than 3 times.
Radius
Figure 18
6. After connecting the copper pipes to the indoor unit, wrap the power cable,
signal cable and the piping together with binding tape.
DO NOT intertwine signal cable with other wires. While bundling these
items together, do not intertwine or cross the signal cable with any other
wiring.
7. Install the refrigerant line through the wall and connect it to the outdoor
unit.
8. Insulate all piping after leak check has been performed.
CAUTION: CONTAINS REFRIGERANT

Check to make sure there is no refrigerant leak after
completing the installation work. If there is a refrigerant
leak, ventilate the area immediately and evacuate the system
(refer to the Evacuation and Charging Process section of
this manual).
1 6 |
4 in (10 cm)
or more
Bosch Climate 5000 Series Multi Zone Ductless Air Conditioner / Heat Pump (06.2022)