Specifications; Appucation Of X-Y Operation 2 - Kenwood CS-1044 Instruction Manual

CRT
Acceleration Voltage
Display Area
V E R T I C A L A X I S
Sensitivity
Attenuator
Input Impedance
Frequency Response
5mV/div t o 5V/div
1 mV/div, 2 mV/div
Rise Time
Signal Delay Time
Crosstalk
Operating Modes
Chop Frequency
Channel Polarity
/ ^ M a x i m u m Input voltage
H O R I Z O N T A L A X I S
Operating Modes
Sensitivity
Input Impedance
Frequency Response
X-Y Phase Difference
ft\ Maximum Input Voltage
S W E E P
Type Type Type
SINGLE-RESET SINGLE-RESET SINGLE-RESET
4

SPECIFICATIONS

C S - 1 0 4 4
150STM31
Rectangular, w i t h internal graticule
Vernier control for fully adjustable sensitivity between steps.
1 Mfi ± 2 % approx. 2 0 pF
DC; DC to 4 0 MHz, - 3 dB
A C ; 5 Hz to 4 0 MHz, - 3 dB
DC; DC t o 1 5 MHz, - 3 dB
A C ; 5 Hz to 1 5 MHz, - 3 dB
8.8 nsec or less (40 MHz)
23.4 nsec or less (1 5 MHz)
Approx.20 nsec on the CRT screen
C H 1 ; single trace
CH2; single trace
ALT; t w o waveforms alternating
CHOP; t w o waveforms chopped
ADD; CH1 + CH2 added display
DC; DC t o 1 MHz, - 3 dB
AC; 5 Hz to 1 MHz, - 3 dB
3 ° or less at 100 kHz
NORM NORM NORM
AUTO AUTO AUTO
Single sweep
1 5 0 Q T M 3 1
Rectangular, w i t h internal graticule
6 kV
8 x 10 div (1 div = 10 mm)
CH1 and CH2
1 mV/div to 5 V/div, ± 3 %
12 steps, 1 mV/div t o 5 V/div in 1-2-5 sequence.
1 Mfi ± 2 % approx. 2 2 pF
DC; DC t o 2 0 MHz, - 3 dB
A C ; 5 Hz t o 2 0 MHz, - 3 dB
DC; DC to 10 MHz, - 3 dB
A C ; 5 Hz to 10 MHz, - 3 dB
17.5 nsec or less (20 MHz)
35 nsec or less (10 MHz)
— 4 0 dB minimum
Approx. 2 5 0 kHz
Normal or inverted, channel 2 only inverted
5 0 0 Vp-p or 2 5 0 V (DC + AC peak)
Input thru CH2, x 10 M A G not included
With trig MODE switch, X-Y operation is selectable
C H 1 ; Y axis
CH2; X axis
Same as vertical axis (CH2)
Same as vertical axis (CH2)
Same as vertical axis (CH2)
Triggering sweep
Sweep free runs in absence of trigger
C S - 1 0 2 5
—
DC; DC t o 5 0 0 kHz, - 3 dB
AC; 5 Hz to 5 0 0 kHz, - 3 dB
3 ° or less at 50 kHz
—