Specifications - Kenwood CS-1065 Instruction Manual

C R T
Acceleration Voltage
Display Area
V E R T I C A L A X I S
Sensitivity
Attenuator
Input Impedance
Frequency Response
5mV/div to 5V/div
1 mV/div, 2 mV/div
Rise Time
Signal Delay Time
Crosstalk
Operating Modes
Chop Frequency
Channel Polarity
/ \ Maximum Input voltage
Non-Distorted Maximum Amplitude
V E R T I C A L A X I S
Sensitivity
Input Resistance
Input Capacitance
Frequency Response
Rise Time
Signal Delay Time
$ \ Maximum Input Voltage
H O R I Z O N T A L A X I S
Operating Modes
Sensitivity
4

SPECIFICATIONS

C S - 1 0 6 5
150TTM31
Rectangular, with internal graticule
12 steps, 1 mV/div to 5 V/div in 1 -2-5 sequence.
Vernier control for fully adjustable sensitivity between steps.
DC; DC to 6 0 MHz, - 3 dB
A C ; 5 Hz to 60 MHz, - 3 dB
DC; DC to 20 MHz, - 3 dB
A C ; 5 Hz to 20 MHz, - 3 dB
5.8 nsec or less (5 mV/div to 5 V/div)
17.5 nsec or less (1 mV/div, 2 mV/div)
Approx.20 nsec on the C R T screen
C H 1 ; single trace
C H 2 ; single trace
DUAL; CH1 and C H 2 , dual trace
ADD; CH1 + C H 2 added as a single trace
TRIPLE; C H 1 , CH2 and CH3 triple trace
Normal or inverted, channel 2 only inverted
500 Vp-p or 2 5 0 V (DC + A C peak)
More than 8 div (DC to 60 MHz)
DC: DC to 60 MHz, - 3 dB
5.8 nsec or less
Input thru C H 2 , x 10 MAG not included
With H0RIZ MODE switch, X-Y operation is selectable
150TTM31
Rectangular, with internal graticule
12 kV
8 x 10 div (1 div = 10 mm)
CH1 and C H 2
1 mV/div to 5 V/div, ± 3 %
1 Mfi ± 2 % , approx. 2 0 pF
DC; DC to 4 0 MHz, - 3 dB
A C ; 5 Hz, to 4 0 MHz, - 3 dB
DC; DC to 1 5 MHz, - 3 dB
A C ; 5 Hz to 1 5 MHz, - 3 dB
8.8 nsec or less (5 mV/div to 5 V/div)
23.4 nsec or less (1 mV/div, 2 mV/div)
— 4 0 dB minimum
Approx. 2 5 0 kHz
More than 8 div (DC to 4 0 MHz)
CH3
0.5 V/div ± 3 %
1 Mi) ± 2 %
Approx 20 pF
DC: DC to 4 0 MHz, - 3 dB
8.8 nsec or less
Same as CH1 and CH2
50 V (DC + A C peak)
C H 1 ; Y axis
C H 2 ; X axis
Same as vertical axis (CH2)
C S - 1 0 4 5