Cisco 7100 Series Quick Start Manual page 20

Start the System (continued)
4
Enter router host name, the enable secret password, enable password, and the virtual
terminal password:
Configuring global parameters:
Enter host name [Router]: sanjose
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: barney
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: betty
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: fred
5
Enter yes or press Return to accept SNMP management; enter no to refuse it:
18
Configure System Management? [yes/no]: no
Configure SNMP Network Management? [yes]: no
Note: The Simple Network Management Protocol (SNMP) is the most widely supported open
standard for network management. It provides a means to access and set configuration and
run-time parameters of routers and communication servers. SNMP defines a set of functions
that can be used to monitor and control network elements.
6
Enter yes or press Return to configure IP routing and select an interior routing protocol:
Configure IP? [yes]: yes
Configure IGRP routing? [yes]: yes
Your IGRP autonomous system number [1]: 15
Configure CLNS? [no]: no
Note: Choose which protocols to support on your interfaces. For IP-only installations, you
can accept the default values for most of the questions. In most cases, you use IP routing. If
you are using IP routing, you must also select an interior routing protocol. You can specify only
one of two interior routing protocols to operate on your system using setup: Interior Gateway
Routing Protocol (IGRP) or Routing Information Protocol (RIP).