Cisco 7100 Series Quick Start Manual page 18

Start the System (continued)
Use the Setup Facility
This section provides a sample of a basic router configuration using the setup facility. The
output from the setup facility varies depending on the Cisco 7100 series model you are
installing. It does not contain a complete example of all possible features that can be used by
the various interfaces.
Note: For information the defaults settings for the various interfaces, and procedures on how
to use autoinstall or global configuration mode to configure the router, refer to Chapter 4,
"Performing a Basic Startup Configuration," in the Cisco 7100 Series VPN Router Installation
and Configuration Guide.
1
Power on the router. After startup, the console screen displays a script and a system banner
similar to the following. When you see this information, you have successfully booted your
router.
16
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Cisco Internetwork Operating System Software
IOS (tm) EGR Software (c7100-P-M), Release Version 12.0(19990204:220751)
[biff-bigrock.sync 122]
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Mon 08-Feb-99 11:26 by biff
Image text-base:0x60008900, data-base:0x609D2000
cisco 7140 (EGR) processor with 90112K/73728K bytes of memory.
R7000 CPU at 262Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache
4 slot midplane, Version 0.1
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706