Table of Contents
Advertisement
Available languages
Available languages
4.
Loosen the bolt shown in Figure 31 securing the belt keeper
bracket and remove the other bolt. Push the belt keeper and
bracket up off the engine pulley.
Loosen
Auger Belt Replacement
1.
Remove the bow-tie clip and flat washer from the ferrule in order
to disconnect the auger idler rod from the brake bracket assem-
bly. See Figure 32.
NOTE: Make sure that the location of the ferrule on the auger
idler rod is maintained.
Hairpin Clip
and Washer
2.
Slip the auger control belt (the front belt) off the engine pulley.
3.
Pull the brake bracket assembly towards the cable guide roller
and unhook the auger cable z-fitting. See Figure 33.
4.
From both sides of the the frame assembly, use a 1/2" wrench to
remove the three hex tap screws securing the frame to the auger
housing assembly. Refer back to Figure 29.
NOTE: Do not remove the lower hex flange lock nut on each side.
SERVICE AND MAINTENANCE
Remove
Figure 31
Ferrule
Auger Idler Rod
Figure 32
5.
Place a block of wood underneath the auger housing as shown in
Figure 34 and separate auger housing from the frame by tilting the
housing forward and pulling up the handles.
6.
Block the impeller with a piece of wood to prevent it from spinning
and use a 1/2" wrench to remove the hex screw and flat washer
from the center of the pulley on the auger housing. See A in Fig. 35.
7.
Lift the brake bracket assembly out of the pulley groove (B in
Figure 35) and slide the pulley assembly off the posts of the auger
pulley adapter (C) to remove the old belt.
NOTE: The pulley adapter may slide off the auger input shaft
when removing the pulley. Use extra caution to ensure the
adapter does fall and/or get damaged when removing the pulley.
8.
Place the new auger belt in the V-groove of the auger pulley and
place the pulley w/belt inside the belt keepers.
9.
Turn the pulley as necessary to align its three slots approximately
with the posts of the pulley adapter, then pivot the brake bracket
assembly away from the pulley groove. While aligning the pulley
slots and adapter posts, push the auger pulley fully onto the
adapter. Refer to Figure 35. Ensure the brake puck of the brake
bracket assembly aligns and is fully seated in the pulley groove.
23
z-fitting
Figure 33
Figure 34
Advertisement
Chapters
Table of Contents
