Table of Contents
Advertisement
Push the Power switch(button) off/on the set(the remote control)
to turn the set off/on.
It can be made Hotel mode.
3. Exit command
- First, set the data of EEPROM(ADDRESS 160) to 80.
Next, Push the Power switch(button) off/on the set(the remote
control) to turn the set off/on.
Then, it is no longer hotel mode.
4. Access command to the Hotel mode setup menu
- <Prerequisite> : It is conditions that the data of
EEPROM(ADDRESS 160) is C0.
In order to display the Hotel mode setup menu, please enter
the following command (within 2 second) .
[[TV]:down + [REMOTE]:TV/AV(3 times)]
Then, the Hotel mode setup menu is displayed.
5. Explain the Hotel mode setup menu
CAUTION
This setup is not valid, unless data of EEPROM(ADDRESS 160)
will be C0, even if each settings were done.
42
Advertisement
Table of Contents
