Glass Tube Assembly - Haier QBJ1-130A Instructions For Use Manual

Assembly Instruction

Glass tube assembly

1. Keep tubes out of the irradiation while assembling the unit or a scald may be
caused.
2. Place the rounded side of rubber seal downwards on the open end of tubes.(A)
3. Insert the tube into base support of locating hole with gentle pressure and twisting
motion.
4. Holding the tube, fix base support into base bracket (B), insert tube into base
support (C).
5. Slide the tube down 1 cm, Slide black rubber seal up the tubes until it sits flush
with tank.
6. Insert one tube on either end of the tank to achieve alignment of unit.
Notice:
1. Make sure the s
2. Place the rounded side of rubber seal downwards on open end of tube.
Slide it down 10 cm. Wet open end of tube to make it easier to insert.
A
B
are clean and well positioned.
ilicon seal ring
Silicon seal ring
Evacuated tubes
Rubber seal
Base bracket
Base support
C
D
6
Evacuated
tubes
Base support
Base bracket
Rubber seal
hold position