Table of Contents
Advertisement
2
Removing the Existing Belt
Cover, Belt, and Bracket
No Parts Required
Procedure
Note:
Clean the area around the belt cover before
removing.
1.
Lower the mower deck to the lowest height-of-cut
position.
2.
Remove the right belt cover
1. Push tab down.
3.
For 48-inch and 52-inch mowers only: Loosen
the bolts holding the right spindle to the mower
deck
(Figure
5).
Note:
This will allow access to the nuts holding
the right belt cover bracket to the mower deck.
(Figure
4).
Figure 4
2. Remove belt cover.
48-inch and 52-inch mower deck shown
1. Right belt cover bracket
2. Washer
4.
Remove the existing right belt cover bracket
(Figure 5
g027729
60-inch and 72-inch mower deck shown
1. Right belt cover bracket
2. Washer
5.
Store the right belt cover, bracket, and hardware
for later use if you remove the bagger blower
and pulley.
6.
Remove and retain the deck belt.
5
Figure 5
3. Flange nut
4. Loosen these bolts.
and
Figure
6).
Figure 6
3. Flange nut
g010497
g009295
Advertisement
Table of Contents
