Technical Description; Installing The Device - Dometic CE99-DF Installation And Operating Manual

Hot and cooking hobs and combinations
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Technical description

5
Technical description
5.1
Function
The device is equipped with an automatic flame monitoring device which automatically interrupts the gas supply
after approx. 20 seconds if the flame goes out.
5.2
Specifications for the different models
The devices are available in different versions:
• CE99-ZF: Cooktop with two burners and safety glass cover
• PI80xx: Cooktop with two to three burners and safety glass cover
• CE99-DF: Cooktop with three burners and safety glass cover
• KSK2007R: Cooktop with three burners and safety glass cover
• PI90x3: Cooktop with three burners and safety glass cover
• MO71x3: Combination with three burners, safety glass cover and a sink
• MO9x22: Combination with two burners, safety glass cover and a sink
The safety glass cover can be used as a work surface when it is closed.
5.3
Control panel
See fig. 1, page 3
6

Installing the device

!
WARNING!
Assembly and installation of the device must only be carried out by specialists. Incor-
rect assembly and installation can result in serious hazards due to the escape of gas.
6.1
Selecting the installation location
When selecting the installation location, observe the following instructions:
• Consider the volume of air required for combustion (chapter "Technical data" on page 28).
• During operation, there must be air vents with a cross-section of at least 150 cm
• Make sure that minimum distances (fig. 2, page 4) are observed.
• Ensure that there are no drafts at the installation location.
6.2
Installing the device
1. Create a cutout according to the installation drawing:
– PI80x2: fig. 3, page 4
– PI80x3: fig. 4, page 5
– PI90x3: fig. 5, page 5
– MO71x3: fig. 6, page 6
– MO9222: fig. 7, page 7
– MO9722: fig. 8, page 8
– CE-99-ZF: fig. 9, page 9
– CE99-DF: fig. 0, page 9
– KSK2007R: fig. a, page 10
2. Affix the device to the worktop using the screws (fig. b, page 10 – fig. d, page 12).
24
Hobs and Combinations
2
in the installation room.
EN

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents