Related Manuals for Rivet King RK-8000S
Summary of Contents for Rivet King RK-8000S
- Page 1 Instruction Manual Model# RK-8000S FOR SALES, SERVICE OR TECH SUPPORT CALL: 1800-BUY-RIVET 1-800-289-7483...
-
Page 2: Table Of Contents
ONTENTS Features Page 3 Safety Page 3 Specifications Page 3 Air supply Page 4 Operation Page 4 Jaw Cleaning Procedure / Jam Remedy Page 5 Maintenance / Service Page 6 Oil Change/Replacement Procedure Valve Spool Assembly Trigger Preventive Maintenance Page 7 Daily Weekly Monthly... -
Page 3: Features
RECOMMENDED BY O NOT USE OUTSIDE DEISNG INTENT OR WITH EQUIPMENT THAT IS NOT THE MANUFACTURER LWAYS DISCONNECT THE AIR SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE OR ADJUSTMENT FITTING OF NOSE EQUIPMENT O NOT OPERATE A TOOL THAT IS DIRECTED TOWARDS ANY PERSON OR WITH THE MANDREL CATCHER OFF THE TOOL ... -
Page 4: Air Supply
AIR SUPPLY The rivet tool is powered by compressed air at an optimum pressure of 5.5 bar (80 psi) The use of a pressure regulator filter/lubricator unit within 3 meters of the tool is highly recommended to extend the life of the tool. Dirt and/or water in the air supply can seriously impact the performance and durability of the tool;... -
Page 5: Jaw Cleaning Procedure / Jam Remedy
AW CLEANING PROCEDURE JAMMED GUN REMEDY 1. Disconnect tool from air supply 2. Leaving the nose piece attached, remove the nose case 3 using the wrench provided by loosening at the wrench point. 3. Fit two wrenches, one on Jaw Case 04 and the other on 08 keeping the nut 09 stationary while unscrewing the jaw casing 04. -
Page 6: Maintenance / Service
AINTENANCE Oil Priming Procedure After 100,000 cycles, or when the tool loses enough stroke and/or power to place rivets in one actuation, a priming procedure may be required. Please use the oil provided with the tool. Replacements are available at 1-800-BUY-RIVET. ... -
Page 7: Preventive Maintenance
REVENTIVE AINTENANCE In order to maintain the tool in a safe working order it is important to carry out regular maintenance as prescribed by the manufacturer. A thorough inspection replacement of all seals within the tool should be carried out after 500,000 placings or annually, whichever is the sooner. Item numbers in parentheses refer to assembly drawing part numbers Daily ... -
Page 8: Schematic
SCHEMATIC... -
Page 9: Part List
SERVICE KITS & SPARES... -
Page 10: Oil Msds
OIL MATERIAL SAFETY DATA SHEET MSDS Priming is ALWAYS necessary after the tool has been dismantled and prior to operating. It may also be necessary to restore the full stroke after considerable use, when the stroke may be reduced and fasteners are not fully placed by one operation of the trigger Oil Details The recommended oil for priming is Mobil DTE 24 or Hyspin VG32 available in 0.51 or one gallon... -
Page 11: Troubleshooting
ROUBLESHOOTING Item numbers in parentheses refer to assembly drawing part numbers on page 9. Problem Possible Cause Remedy More than one Air leak Tighten joints or replace components operation of the trigger Insufficient air pressure Adjust air pressure to within ... -
Page 12: Warranty
Warranty Statement: Industrial Rivet & Fastener Co. Inc. (hereinafter “IRF”), hereby warrants to the initial retail customer and original distributor (“Warrantee”) only that its products will be free from defects in material and workmanship for a period of 1 year from the purchase date, provided that the products are used in accordance with “IRF’s”...
Need help?
Do you have a question about the RK-8000S and is the answer not in the manual?
Questions and answers