Polygroup SUMMER WAVES RP800 Owner's Manual page 10

5. Remove the Seal Top Retainer
the Volute Housing Inlet and Outlet with petroleum jelly. Hold the Filter Pump Canister
Pump Canister so that the outlet on the volute housing extends out of the opening in the side of the Filter Pump Canister. Insert the pump until the two ribs on the
inlet of the volute housing protrude through the bottom of the filter case. Reach down inside the filter case and place the Pump Retaining Nut
volute housing inlet. Twist the Nut clockwise until it is snug. (See Fig. 2)
8
6. Lubricate the O-rings on the Filter Pump Canister Inlet and on the
Suction Fitting with petroleum jelly then connect the Hose from the
Suction Fitting to the Filter Pump Canister Inlet.
Outside Pool Wall
8. Tighten all Hose Clamps to prevent water leakage.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
, Seal Top , and Filter Cartridge
MST. Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
from the assembled Filter Pump Canister. Lubricate the pump O-rings located at
securely, and insert motor assembly (pump) from the bottom of the Filter
Volute
Housing
Outlet
Motor
Assembly
(Pump)
FIG. 2
7. Lubricate the O-ring on the Return Fitting and on the Connect the Hose
from the pool Return Fitting to the Pump outlet.
Outside Pool Wall
9. Do not plug in the filter pump at this point. Begin to fill the pool with
water until the water level reaches the fill line.
over the top of the
7
Volute
Housing
Inlet
1-6
8
10