Table of Contents
Advertisement
2.4 SIM/UIM card installed
If your router has SIM/UIM card protector, please remove it, insert the sim card correctly,
and fix the protector.
If your router has no SIM/UIM card protector, please insert the sim card correctly.
Notes:
SIM/UIM card does not reach the designated position, the equipment can not find a card,
can't work normally, therefore inserted a try to check again for a
2.5 The installation of terminal blocks
The following is for version with terminal blocks only:
H750 uses pluggable terminals to connect the user's data and the power supply. Spacing:
3.81mm, 10 Pin; User data and power supply suggestion: 14~24AWG. Please refer to the
table 2-4 for the interface definition of the power cable and connection sequence. Specific
interface definition of the power cable and connection sequence you can read on the labels of
H750 products. Using 14~24AWG cable and referring to H750 products labels or the bellowed
interface definition and connection sequence, you need to use the oblate screw driver to fix the
cable to the connecting jacks of the pluggable terminal. After successfully connection, you
need to insert the terminal into the corresponding position in the bottom of the H750 products.
Notes: Connection sequence should be accurate
about 7mm. (For safety, insulating striping length should be too long). Please refer to the
picture.
E-Lins Technology Co.,Limited
Tel: +86-755-29230581 E-mail: sales@e-lins.com
H750 User Manual
is stuck fast.
SIM Card
Cable's insulating striping length is
。
www.e-lins.com
Advertisement
Table of Contents
