Table of Contents
Advertisement
Washing sequence
Wash timer
Water inlet
(To set to below 2 minute,
entrance
first set to 5 minute then
turn it back. It can increase
the service life of the timer).
Wash
1.Water-filling selector
Set the water inlet selector at the "WASH" side.
(Figure 1)
2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
3.Put in the laundries. If the water quantity is
insufficient, please add water.
4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the laundries.
(Figure 4)
6.After washing, Set the "WASH SELECTOR" at
"DRAIN" in order to discharge the water. (Figure 5).
Wash selector
(standard current,
strong current)
OFF
15
3
12
6
9
Water-filling selector
Spin timer
(To set to below 1 minute,
first set to 2 minute then
turn it back. It can increase
the service life of the timer).
OFF
5
1
4
2
3
WASH
15
12
SPIN
Figure 1
Figure 2
Figure 3
OFF
3
Figure 4
6
9
Figure 5
9
Advertisement
Table of Contents
