Table of Contents
Advertisement
Installation and adjustment
Please install and adjust the machine according to the requirement of
the manual. It is very important to your security and correct operating
the machine.
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be
less than 10cm , or the drainage will
not be smooth enough and cause
incomplete drainage.
2.Do not step on or press the drain hose.
Install the lint filter
After openning the package,please take out the lint
filter from the document bag,install it to the filter frame
of the cabinet.See to the figure.
Install the water inlet hose; Select the water level
Use the new water inlet hose provided with the
machine to connect to the water faucet.
Old hose sets should not be reused.
Insert the water inlet hose into the water-filling
entrance on the control panel directly. (pull it
out to dismantle it)
Select water level according to the
quantity of the laundries.
Attention:
In water filling, do not exceed
the"Maximum" water level. Otherwise
the water may overflow out of the
washing machine.
4
<10cm
4.If extra drain hose is needed , the inner
Water-filling
entrance cover
Maximum
(About 79L)
Medium
(about 66L)
Minimum
(About 48L)
3 If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
diameter of the extra hose shall not less
than 30mm, and the length shall not exceed
1.5m.
<1.5m
Filter frame
Max
Medium
Min
> 30mm
Lint filter
Water inlet hose
Water-filling
entrance
Advertisement
Table of Contents
