Usage Of The Drain Hose - Haier HWM80-68B User Manual

Install the lint filter
After opening the package, please take out the lint
filter from the document bag, install it to the filter cover
of inner tub. See to the figure.
How to change the direction of the drain hose
1.Dismount the back cover of the washing machine.
2.Lay down the washing machine gently with the front
side facing the ground. Use cross screwdriver to
loosen the eight screws. Take off the bottom plate.
back
front
3.Put down the outer drain hose. Twist the drain hose nut
counterclockwise to take it off as indicated in Figure 1.
Take off the drain hose rack. Put the drain hose into
the cabinet as indicated in Figure 2.
Loosen
Outer
drain hose
Drain hose nut
Drain hose rack
Figure 1

Usage of the drain hose

The drain hose shall drain smoothly
1.The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not ramp or press the drain hose.
3.If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
4.Dismount the protecting cover of the drain outlet at the
5.Extend the drain hose out of the other side. Fix the drain
bottom plate
drain outlet
protecting
soft item
cover
7.Install the bottom plate (method the same as stated
drain hose nut
Figure 2
4.If extra drain hose is needed, please
Inner tub
other side as indicated in Figure 3.
hose onto the cabinet with the drain hose rack. Set the
drain hose nut on, and fasten the nut to the direction
indicated in the figure, as per Figure 4.
Figure 3
6.Install the protecting cover of the drain outlet to the other
side, as indicated in Figure 5.
above). Lift up the washing
machine gently.
make separate purchase. The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
If the extra hose is too long, cut it either
at point A or B.
Lint filter
fasten
Figure 4
Figure 5