Chamberlain INSL24UL Installation Manual page 45

Position
The location of the panel(s) is critical to the success of the installation. In
general, the panel(s) should be mounted using the provided angle bracket
facing due south. The solar panel(s) should be mounted in an area clear of
all obstructions and shade from buildings and trees. If the panel(s) is not
casting a shadow, the battery is not being charged.
NOTE: Tall trees or buildings that do not shade the solar panel(s) in the
summer could shade the solar panel(s) during the winter months when the
sun sits lower in the sky.
Sun's position
Installation
Solar panel(s) MUST be installed facing south. Use a compass to determine direction. Below are general instructions for installing the solar panel(s). Your
installation may vary slightly depending on the solar panel purchased.
1. Position the mounting bracket on the mounting surface. Mark and drill holes.
2. Secure the solar panel to the mounting bracket using the hex bolts, hex nuts and washers provided.
3. Secure the solar panel to the mounting surface using lag screws provided.
1
SOLAR PANELS
AMERICAN
Chart assumes: copper wire, 65°C, 5% drop, 30V nominal
TIP: The area around the solar panel(s)
should be clear of shadows or obstructions
to the sun for a 180° arc east to west.
South
2
Hex Nut
Washer
Hex Bolt
45
MAXIMUM WIRE LENGTH
20 WATTS OF
WIRE PANELS
GAUGE
(AWG)
16 235 (71.6 m)
14 375 (114.3 m)
12 600 (182.9 m)
10 940 (286.5 m)
180°
3
40 WATTS OF
60 WATTS OF
PANELS
PANELS
115 (35.1 m) 80 (24.4 m)
190 (57.9 m) 125 (38.1 m)
300 (91.4 m) 200 (61 m)
475 (144.8 m) 315 (96 m)
Summer Sun Height
Winter Sun Height
Up to 15°
South
TIP: To optimize the system for winter
operation the angle can be increased an
additional 15° (solar panel(s) sits more
vertical).
Mounted panel must face SOUTH
Mounting
Surface
Mounting
Surface