Table of Contents
Advertisement
L C D D i s p l a y
Monitor Arm or Wallmount Plate Installation
The Panel PC has Video Electronics Standards Association
(VESA) standard mounting holes tapped into the rear panel.
The standard holes are M4 set at 100mm x 100mm apart.
VESA Mounting Holes
To mount the Panel PC onto a monitor arm or wallmount plate,
please follow the steps below.
Step 1: Line up the threaded holes on the monitor rear panel with
the screw holes on the monitor arm or wallmount plate.
Step 2: Secure the monitor to the arm or stand with the retention
screws supplied with the monitor arm or stand.
Chapter 2 Hardware Installation
2-8
O P D - 2 1 5 E
Advertisement
Table of Contents
