Inverter Display Panel; Error Codes - Progressive Dynamics PD1610 Quick Reference Manual

Inverter Display Panel

Select Power PDI Remote Port
Button Button (use with PD1601)
Display
Figure 6
Inverter on-board Display Panel
Display Features

Power Button: Press to turn on; hold to turn off

Select Button: Cycles between display states:
Input Voltage, Output Voltage, Output
Power, Standby, Error Code (if applicable)

Power Indicator: Lights up green when the inverter is on

Shore Indicator: Lights up yellow when AC input is detected

Low Bat Warning Indicator: Lights up red when the battery
is nearing the end of its charge

PDI Remote Port for externally mounted display

RV-C Port for communication with a RV-C compatible hub
Figure 7
Inverter Remote Display
Low Bat Warning Indicator
Consult a licensed electrician or RV technician for installation assistance
RV-C Port
(use with RV-C
Compatible Device)
Power Indicator
Figure 8
Display Indicator (Inverter on-board and remote control)

ERROR CODES

Error Code Condition
E-1 Low battery
voltage detected
E-2 High battery
voltage shutdown
AC output
E-3
overload
shutdown
E-4 Over-temperature
shutdown
E-5
Internal Error
E-6
Short Circuit
E-7 DC Voltage
Failure
Fault Indicator Shore Power Indicator
Action

Re-charge the battery

Check DC cable size

Tighten DC connections

Disconnect external sources (alternator
or charger)

Evaluate the loads connected to the AC
outlet of the unit. Loads may need to be
reduced.

Reduce load to the AC output

Ensure that the inverter is in a dry, well
ventilated space with adequate air flow

Ambient temperature may be too high

Ensure all connections are tightened

Contact the PDI Service Department

Look for damaged AC loads

Look for faulty AC wiring

Evaluate peak power requirements for
all loads

Ensure DC connections are tightened

Ensure battery has sufficient capacity

Review minimum wire length and size
requirements
814420H