Configure Vlan - TP-Link Omada EAP620 User Manual

Destination Port
Status


iipe
When External Web Portal is configured in the portal configuration, you should set the IP address
and subnet mask of the external web server as the Destination IP Range. As for Source IP Range,
Source MAC Address and Destination Port, you can simply keep them as empty or configure them
according to your actual needs.
3. Click OK to add the policy.

2.3 Configure VLAN

Wireless VLAN is used to set VLANs for the wireless networks. With this feature, the EAP
can work together with the switches supporting 802.1Q VLAN. Traffic from the clients
in different wireless networks is added with different VLAN tags according to the VLAN
settings of the wireless networks. Then the wireless clients in different VLANs cannot
directly communicate with each other. Note that the traffic from the wired clients will not
be added with VLAN tags.
To configure VLAN for the wireless network, go to the Wireless > VLAN page.
Follow the steps below to configure VLAN on this page.
1. Select the specific SSID in the list to configure the VLAN.
2. In the VLAN column and select Enable to enable the VLAN function on the SSID.
Specify the port number of the service. When using this service, the
clients can access the specific resources without authentication.
Leaving the field empty means that clients can access the specific
resources no matter what service they are using.
Check the box to enable the policy.
35