Jump-Starting - Yamaha VIKING 2021 Owner's Manual

1
1. Positive battery lead (red)
2. Battery band
3. Negative battery lead (black)
4. Install the air intake duct panel by install-
ing the quick fastener screws.
5. Install the hood.
9
TIP
 Make sure the battery leads are installed as
shown.
 Fully charge the battery before installing it.
2
3
EBU32651

Jump-starting

Jump-starting the vehicle should be avoided.
The battery should be removed and charged
instead.
However, if the vehicle must be jump-started,
proceed as follows.
EWB03430
WARNING
To avoid battery explosion and/or serious
damage to the electrical system:
 Do not connect the negative lead of the
jumper cable to the negative terminal of
the battery.
 Do not touch the positive lead of the
jumper cable to the negative lead.
 Do not reverse the polarity of the jumper
cables when connecting to the batteries.
1. Turn the key to "
2. Remove the hood. (See page 9-9.)
3. Using a charged 12-volt battery, connect
the positive lead of the jumper cable to
the positive terminal of the battery in the
9-46
" (off).