Samsung NV66F3523BS User Manual page 150

Installation in the cabinet
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of
the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic
surfaces or adhesive from the heat.
There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed. For
ventilation, a gap of about 50 mm should be left between the lower shelf and the supporting wall. If the
oven is to be installed below a hob, the hob's installation instructions should be followed.
Min.550
370
Max.50
595
572 550
595
545
21
built-in
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make
sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and
release the 2 screws on the both sides of the oven.
Warning: The built-in furniture must have a minimum ventilation gap for Air-flow as shown
on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.
The front exterior of the oven such as handle is different model by model. But the size of the
oven in the picture is same.
NV70F35-NV66F35 Series_OL_DG68-00522L-03_EN.indd 10
Min.560
Min.50
560
Min.590 ~ Max.600
Min.460 x Min.50
English - 10
Min.550
Min.560
175
370
560
115
595
572 550
Max. 476
595 Min.460 x Min.50
Max.
545
464
21
built-in + built-under
Min.600
built-under
2015-03-02 2:21:16