Table of Contents
Advertisement
DECORATIVE MEDIA VESSEL AND MEDIA
1.
Remove offset frame and glass frame. See pages 48-49.
2. Remove burner from carton inside firebox.
3.
Carefully unpack Decorative Media Vessel.
4. Place Decorative Media Vessel over pilot in center of firebox
floor. Pilot will protrude through the rectangular opening in
the vessel. See Figure 50.
5.
Insert Trim Ring and Ring Burner into Media Vessel. Look
through the perforated floor material to fit the air shutter
over the orifice holder. The Ring Burner air shutter will point
directly to the right. See Figures 51.
Page 30
Figure 50
RING
BURNER
TRIM
RING
Figure 51
6.
Fit the Center Burner and Center Burner Screen together as
shown in Figure 52.
7.
Insert Center Burner through the Ring Burner. Look through
the perforated floor material to fit the air shutter over the ori-
fice holder. The Center Burner air shutter will point towards
the front and to the right. See Figures 53 and 54. Snap
center burner screen into Ring Burner so that it is flush with
the top surface of the Ring Burner. See Figure 53.
Figure 52
Figure 53
32929-11-0817
Advertisement
Table of Contents
