Decorative Accessory Installation - Empire Comfort Systems VFLC10IN32N-1 Installation Instructions And Owner's Manual

DECORATIVE ACCESSORY INSTALLATION

Failure to position the parts in accordance with the dia-
grams and instructions below or failure to use only parts
specifically approved for use with this heater may result in
property damage or personal injury.
NOTICE: The Loft series burners may be operated with or
without the Decorative accessory options. Follow the direc-
tions below should you choose to enhance your Loft burner
with any one of the available decorative options.
DECORATIVE GLASS ACCESSORY PLACEMENT
The Decorative Glass options are available in various colors and
package sizes. Choose the size appropriate for your fireplace:
VFLc20In will accept 1 sq. ft. of decorative glass or rock.
VFLc28In will accept 1-1/2 sq. ft. of decorative glass or rock.
See Page 7.
Use gloves and eye protection while applying the decora-
tive glass.
INSTALLATION
1. Application of the Decorative Glass should only be performed
after the Loft burner has been fully installed, secured and test-
ed for leaks. If operating the burner with a Remote Control,
make sure all batteries are installed and that the Loft burner
operates with the remote correctly.
3. To install the Decorative Glass, cut off a corner of the plastic
bag and proceed to apply the glass to the rear shelf on the
Loft burner (area behind the burner). Apply only enough glass
to the Top Cover to cover the black metal surfaces. Do not
allow the glass to fall around the burner tube. See Figures
21 and 22. Apply the remaining decorative glass to the front
sloped surface of the Top Cover. Start by placing the glass
along the front edge of the top cover, then gradually place the
glass up the sloped top until completely covered. Do not allow
the glass to fall around the burner tube. see Figure 23.
Never place glass on top of or next to the burner.
Page 22
WARNING
CAUTION
CAUTION
Figure 21
Figure 22
Figure 23
39235-1-0219