Decorative Glass Accessory Installation - Empire Comfort Systems VFLL38FP30L Installation Instructions And Owner's Manual

DECORATIVE GLASS ACCESSORY INSTALLATION

Failure to position the parts in accordance with the diagrams
and instructions below or failure to use only parts specifically
approved for use with this fireplace may result in property
damage or personal injury.
NOTICE: The burner may be operated with or without the
Decorative accessory options. Follow the directions below
should you choose to enhance your burner with any one of
the available decorative options.
NOTE: VFLL38 burner pan will accept 1.75 square feet of
Decorative Glass. VFLL48 burner pan will accept 2.25 square
feet of Decorative Glass.
DECORATIVE gLASS AND ROCKS ACCESSORy
PLACEMENT
Do not use more glass than recommended.
Glass or rocks must not be more than a single layer.
Never place media materials on or next to the burner.
The Decorative Glass options are available in various colors and
package sizes. Choose the size appropriate for your fireplaces.
See list on page 8.
Use of gloves and eye protection is required while applying the
decorative glass or rocks.
Application of the Decorative glass or Rocks should only be
performed after the burner has been fully installed, secured
and tested for leaks. If operating the burner with a Remote
Control, make sure all batteries are installed and that the
burner operates with the remote correctly.
Do not use real rocks or glass. Use decorative rocks and
decorative glass from the accessories listed on page 8.
34846-2-1016
WARNING
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
INSTALLATION
1. Remove glass front from fireplace by lifting the glass front
up, sliding it to the right, and then carefully angle left side out
of the slots. See Figures 40 - 43.
Figure 40
Figure 41
Figure 42
Figure 43
Page 27