Introduction; Introduction Controls - Haier HLC24XSL2 Owner's Manual

Introduction

Controls
This is a simplified representation of the TV front panel, side panel control buttons and side inputs.
TV Side panel controls and connections
1 POWER
Press to turn on and off the TV.
Menu display. Press to access the on-screen
2
MENU
menu display.
Press to access the input source mode. Press
repeatedly to change the source to the one
3
INPUT
you want to watch. In the MENU screen, the
INPUT button serves as the ENTER button.
Press to adjust the volume. In the MENU screen,
4 VOL +/-
these buttons serve as left/right buttons.
DVD panel controls
DVD
slot
load
Connecting a DC input
A
Connect one end of the power adapter to the back
of the TV in the DC input.
B
Connect the other end of the power adapter to the
power, as shown in the figure.
Insert DVD with label
towards back (Silver "shiny"
side facing towards you.)
Press to scan through channels. To scan
quickly through channels, press and hold
5 CH+/-
down either+/-. In the MENU screen these
buttons serve as up/down buttons.
6 Power indicator
Receivers IR signals from the remote control.
7 Remote Sensor
Do not put anything near the sensor, which
may block the remote control signal.
STOP:
Press to stop the DVD disc.
PLAY/PAUSE:
Press to play the DVD program disc, and press again
to pause the DVD program.
OPEN/CLOSE:
Press to open the disc tray, and press again to close
the tray.
PREV:
Press to play the previous program.
NEXT:
Press to play the next program.
Haier LED HDTV/DVD
Introduction
EN-4