Making Adjustments - Brother 888-P00 Installation And Operation Manual

Making Adjustments

Your stitch pattern may sometimes turn out poorly, depending
on the type or thickness of fabric, the stabilizer material used,
sewing speed, etc. If your sewing does not turn out well, sew
trial stitches using the same conditions as the real sewing, and
adjust the stitch pattern as explained below. If the stitch
pattern does not turn out well even after making adjustments
based on the stitch pattern described below, make
adjustments for each stitch pattern individually.
Memo
• This adjustment can be made to
stippling stitch),
patterns from the following categories.
a Touch and select
b Attach monogramming foot "N" and sew the stitch
pattern.
Note
• Be sure to use monogramming foot "N".
Adjustments may not be made correctly with any
other presser foot.
c Compare the finished stitch pattern to the illustration
of the correct stitch pattern below.
d Touch , and then adjust the stitch pattern with the
[Fine Adjust Verti.] display. (page 1 of the settings
screen)
 If the stitch pattern is bunched:
Touch in the [Fine Adjust Verti.] display.
 The displayed value increases each time the key is
touched and the stitch pattern will lengthen.
(1-30 Quilting
(4-15 eyelet stitch) and stitch
(5-31).
 If the stitch pattern has gaps:
Touch in the [Fine Adjust Verti.] display.
 The displayed value decreases each time the key is
touched and the stitch pattern will shorten.
e Sew the stitch pattern again.
• If the stitch pattern still comes out poorly, make
adjustments again. Adjust until the stitch pattern
comes out correctly.
f Touch to return to the original screen.
Making Adjustments
3
59