Adjusting The Thread Tension - Brother 888-P00 Installation And Operation Manual

Adjusting the Thread Tension

Adjusting the Thread Tension
You may need to change the thread tension, depending on the
fabric and thread being used.
■ Correct thread tension
The upper thread and the bobbin thread should cross near
the center of the fabric. Only the upper thread should be
visible from the right side of the fabric, and only the
bobbin thread should be visible from the wrong side of the
fabric.
1
2
3
4
■ Upper thread is too tight
If the bobbin thread is visible from the right side of the
fabric, the upper thread is too tight. Loosen the thread
tension.
Note
• If the bobbin thread was incorrectly threaded, the
upper thread may be too tight. In this case, refer to
"Installing the bobbin" on page 22 and rethread the
bobbin thread.
1
2
3
4 5
Turn the thread tension dial counterclockwise to loosen the
upper thread tension.
■ Upper thread is too loose
If the upper thread is visible from the wrong side of the
fabric, the upper thread is too loose. Tighten the thread
tension.
Note
• If the upper thread was incorrectly threaded, the
upper thread may be too loose. In this case, refer
to "Upper Threading" on page 23 and rethread the
upper thread.
1 5
2
3
4
36
1 Wrong side of fabric
2 Right side of fabric
3 Upper thread
4 Bobbin thread
1 Wrong side of fabric
2 Right side of fabric
3 Upper thread
4 Bobbin thread
5 The bobbin thread is visible
from the right side of the
fabric.
1 Wrong side of fabric
2 Right side of fabric
3 Upper thread
4 Bobbin thread
5 The upper thread is visible
from the wrong side of the
fabric.
Turn the thread tension dial clockwise to tighten the upper
thread tension.
Note
• If the upper thread is not threaded correctly or the
bobbin is not installed correctly, it may not be
possible to set the correct thread tension. If the
correct thread tension cannot be achieved,
rethread the upper thread and insert the bobbin
correctly.