Software Program Informational Screens - Bunn Ultra NX Service & Repair Manual

SOFTWARE PROGRAM INFORMATIONAL SCREENS

Display Temp and Torque Screens
The TEMP & TORQUE mode is typically used for seeing real time component On/Off operation, product
thickness, cooling drum and hot gas temperature for troubleshooting purposes.
Press and hold the left and right hidden buttons for 5 seconds to display the TEMP & TORQUE screen. The
temperature of each cooling drum and the hot gas temperature will toggle back and forth. The auger torque
is displayed continuously. Press and release the hidden buttons to return to HOME SCREEN.
I
O
Left Torque Fan State Compressor State
I
31 - FAN CMP 14 -
O
28° L
Left Barrel Temp
Screen Information and Definition:
Small Block (-): Left or Right Refrigerant Solenoid is OFF
Large Block ( ): Left or Right Refrigerant Solenoid is ON
Lower case fan: Means condenser fan is not operating.
Upper case FAN: Means condenser fan is powered and operating.
Lower case cmp: Means compressor is not operating.
Upper case CMP: Means compressor is powered and operating.
Lower case htr: Means the PTC heater is off.
Upper case HTR: Means the PTC heater is on.
Upper Row Left or Right Number: Means a real time operation number (torque) related to the Daily Operations
"Thickness" menu setting which is multiplied by three. Reference "Service Section - Auger Shaft Assembly".
SET THICKNESS
This function adjusts the ice consistency, or torque of each auger when answered YES (Right Dot). Two
screens will appear for left and right. The operator can scroll through a range of a minimum of 1 (Center Dot)
to a maximum of 16 (Right Dot). Factory default is 7.
I
TEST THICKNESS ?
O
NO NEXT YES
10:45:30 AM
off off
press & hold
Example: Informational Screens below will
alternate back and forth.
Right Torque
46° R
Right Barrel Temp
I
O
I
DISPLAY
O
TEMP & TORQUE
Left Valve State
I
31 - fan cmp 14
O
htr
Left PTC
Heater State
LEFT 10
7
Right Valve State
72°H htr
Right PTC
Hot Gas
Heater State
Temperature
I
O
RIGHT 7