Bunn Ultra NX Service & Repair Manual page 13

ULTRA PM Instructions
11. Replace the auger shaft
seals. P/N: 26780.0000. Apply
lubricant (M2550.0000) to the
auger shaft seals and install
on the shafts.
13. Carefully slide the faucet valve up to remove the spring and
faucet seal. Replace the faucet seal with P/N: 32268.1000
NOTE: Krytox grease to be applied sparingly between the motor and auger shafts
PREVENTIVE MAINTENANCE
10. Remove the cooling drum
seal from the rear of the drum.
Replace the seal with P/N:
32079.0001.
Seal
13
12. Remove dispense handles.
Spread the left side of the
handle first, then the other
and disconnect from the
hopper.
14. Check alignment for the cooling
drums (see next page).
continued >