Bunn Ultra NX Service & Repair Manual page 18

TROUBLESHOOTING
Freezes, but not
thick enough
Ambient
Adjust thickness Brix ratio Too much
temperature
screen higher too high
alcohol in
too hot
product
Check for slightly Recommended
Adjust
bent auger shaft for indoor
product
pins and/or weak
use only
torsion springs.
Check for dirty
or worn seals and
bushings.
No hood lamps
Is dispenser in
No
"chill" or Yes
"ice"mode?
Are the hood
Set into
lamp cords Yes
No
"DAY" mode
connected to the
machine left and
right magnetic
connectors?
Connect lamps cords Verify lamp circuit for 24vdc
18 continued >