Bunn Ultra NX Service & Repair Manual page 59

SERVICE - RIGHT SIDE PANEL COMPONENTS
Start and Run Capacitor
FIG. 44 START & RUN CAPACITOR
WARNING: Part Removal & Replacement:
Follow instruction outlined under Start and Run
Capacitor Test Procedure to ensure the capacitor
is completely discharged before removal and
replacement of capacitor.
1. Disconnect power supply to the machine.
2. With left, right and front panel removed, locate
the capacitor being replaced.
3. Note the position of the capacitor wires onto the
start relay.
4. Disconnect capacitor wires from the start relay.
5. Use a 1/2" socket or wrench to remove the nut
securing the capacitor to the machine frame.
Retain nut.
6. install replacement capacitor and secure with
retained nut from step 5.
7. Connect capacitor wires to the proper terminal
number on the start relay that was noted in
step 3.
59