Table of Contents
Advertisement
OPERATION
FIGURE 3-1. CELP VOICE CHANNEL MODULE, FRONT PANEL
3-2
S I G N A L
E
M
I n S v c e
A RED LED INDICATOR LIGHTS WHEN AN ALARM
CONDITION EXISTS IN THE CHANNEL. SOME
POSSIBLE ALARM CONDITIONS ARE: TRANSMIT
CLOCK BAD, RECEIVE CLOCK BAD, CHANNEL OUT
OF SYNC AND DIAGNOSTIC TESTS IN PROGRESS.
C h a n
THE LED ALSO LIGHTS IF THE CARD IS INSTALLED
A l m
IN AN UNDEFINED SLOT.
TEST POINT FOR BRIDGED MEASUREMENT OF
VOICE CHANNEL VF INPUT LEVEL TO THE
L E V E L
TRANSMIT SECTION. TEST POINT ISOLATED
THROUGH 10-KILOHM RESISTOR. INPUT
LEVELS SHOULD BE 0 dBm OR –16.0 dBm. THIS
TEST POINT IS A HIGH IMPEDANCE INPUT AND
V F I n
IS NOT FOR INJECTION OF TONES.
V F O u t
G n d
TEST POINT FOR BRIDGED MEASUREMENT OF
VOICE CHANNEL VF OUTPUT LEVEL FROM THE
RECEIVE SECTION. TEST POINT ISOLATED
THROUGH 10-KILOHM RESISTOR. OUTPUT
CELP
LEVELS SHOULD BE 0 dBm OR +7.0 dBm
VOICE
CHAN
ANALOG GROUND POINT FOR VF INPUT
AND VF OUTPUT MEASUREMENT.
The E&M and Alarm indicators are still functional
when the card is not in service.
AMBER LED LIGHTS WHEN THE E-LEAD
OF THE VOICE CHANNEL IS IN A BUSY
STATE. OUTPUT FROM THE VOICE
CHANNEL IS IN THE FORM OF A SOLID
STATE SWITCH. LOW RESISTANCE
EQUALS A BUSY CONDITION (E-LEAD
TO GROUND). E-SIGNAL IS A PRODUCT
OF THE REMOTE CHANNELS M-SIGNAL.
AMBER LED LIGHTS WHEN THE M-LEAD
OF THE VOICE CHANNEL IS IN A BUSY
STATE.
A GREEN LED INDICATOR LIGHTS WHEN THE
CHANNEL IN THE CURRENTLY ACTIVE TDM
CONFIGURATION,INDICATING THAT THE CARD IS
EITHER OPERATING OR PREPARED TO OPERATE
ACCORDING TO THE PARAMETERS ENTERED FOR
THAT CHANNEL IN THE ACTIVE CONFIGURATION.
WHEN OFF, THE CHANNEL IS OUT OF SERVICE.
WHEN OUT OF SERVICE, THE CONTROL LEADS
ARE CONDITIONED.
NOTE
Advertisement
Table of Contents
