Table of Contents
Advertisement
INSTALLATION
2-2
There is one hardware option on the piggyback card. That option is
described in Table 2-1.
TABLE 2-1. CELP PLUG-IN OPTION, SIGNALING TYPE
Feature
E&M Signaling
AC15 Signaling
Note that switch SW1 on the piggyback card has been adjusted at the
factory. Do not under any circumstances change the settings of SW1 on
the piggyback card.
Figure 2-1 shows the location of the option switches and jumpers on the
CELP base card.
Tables 2-3 through 2-10 provide the information necessary to configure the
CELP Voice Channel Module for the TMS-3000.
Jumper X1
E&M
Normal jumper position
AC15
Future use jumper position
Application
Advertisement
Table of Contents
