Advertisement
Quick Links
Instructions
Uni-Drum Supply
System Safety Kit
Prevents ram from lowering when the safety pins are installed. For professional use only.
Part No. 26B772, 26B774
Important Safety Instructions
Read all warnings and instructions in this
manual and in manual 309028 before
using the equipment. Save all
instructions.
26B772
3A8499A
26B774
EN
Advertisement
Related Manuals for Graco 26B772
Summary of Contents for Graco 26B772
- Page 1 Uni-Drum Supply System Safety Kit 3A8499A Prevents ram from lowering when the safety pins are installed. For professional use only. Part No. 26B772, 26B774 Important Safety Instructions Read all warnings and instructions in this manual and in manual 309028 before using the equipment.
-
Page 2: Component Identification
PIN, safety, hitch 133305 PIN, clevis 15G945 CABLE, lanyard, 24 in. 18D256† PLATE, base, lock out 15G946 BOLT, U, 1/2 x 8.375 133306 SCREW, HHC Parts included with 26B772 only. 123389 SCREW 101971 WASHER, thrust † Parts included with 26B774 only. 3A8499A... -
Page 3: Installation And Setup
Installation and Setup Installation and Setup NOTE: It is recommended to perform steps 1-3 with 2. Attach the support bracket (120) to the inner support equipment positioned on the floor or on an assembly bar (103) using the pin (122). bench. - Page 4 Installation and Setup 8. After the air pressure has been relieved, remove the not fully tighten hardware. Keep loose for Ram Down air line (G) running from the top of the adjustment. Final torques to be applied in step 16. Pneumatic Logic Panel to the ram cross bar.
- Page 5 Installation and Setup 26B772 26B772 Left-Handed Unit Right-Handed Unit 26B774 26B774 Left-Handed Unit Right-Handed Unit 13. Line up the two 3/8 in. mounting holes on the inner 17. After Installation is complete, close the drain cocks, support bracket (120) with the threaded 3/8 in. holes make all pneumatic connections and open the Main on the base plates (104).
- Page 6 Using the Two Safety Pins Using the Two Safety Pins 1. Turn the RAM POSITION Switch (A) to RAISE, then press the RAM UP Pushbutton to move the ram to the fully raised position. 2. To lock ram in the fully raised position, move the RAM POSITION Switch to the HOLD/NEUTRAL position and insert both safety hitch pins (106) into the outer support bars (102) and install both pin lock...
-
Page 7: California Proposition 65
California Proposition 65 California Proposition 65 CALIFORNIA RESIDENTS WARNING: Cancer and reproductive harm – www.P65warnings.ca.gov. 3A8499A... - Page 8 Original instructions. This manual contains English. MM 3A8499 Graco Headquarters: Minneapolis International Offices: Belgium, China, Japan, Korea GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA Copyright 2021, Graco Inc. All Graco manufacturing locations are registered to ISO 9001. www.graco.com...