ParaZero SafeAir Phantom Configuration Instructions

SafeAir Phantom/ Mavic ASTM Configuration Instructions
Please follow the outlined instructions and operational tips.

Configuration

1. Install the SafeAir device and the ASTM Add-on as instructed:
SafeAir Mavic/
2. In order to update your SafeAir device, pair it with the remote control
together with the Professional Kit, please follow these instructions.
Make sure your device is updated to its latest version:
Firmware version
Configuration
version
3. Charge the system for at least 1 hour.

Before Takeoff

If this is the first installation of the system on the drone follow the instructions in
the manual.
1. When powering up the system check that a green LED appears initially
(indicating the battery is full)
2. After system finishes boot up sequence the LED changes to blue (if the RC is
turned off or not configured, a flashing yellow LED appears)
3. Press the trigger button and check that the system LED blinks in yellow
(might be blue and yellow). Since the SafeAir is not armed, the parachute will
not deploy)

After Takeoff

When reaching an altitude of 10 m/33 ft. wait for 3 seconds. At this point the
system should be armed. The buzzer should beep once.

After Landing

After landing wait 3 seconds. At this point the system should disarm and the
buzzer should beep twice
ParaZero proprietary remote control version
SafeAir Phantom.
SafeAir Phantom
1.30 (March 21, 2019)
1.22 (September 25, 2019) 1.0 (June 16, 2019)
ASTM configuration manual – PRZ RC version v1.2
SafeAir Mavic
1.31 (factory settings)