Section 2: Assembling Procedure
May 2022
•
Figure 3
Figure 4
!
WARNING
Pay attention not to damage the joint surfaces of the cover/enclosurer.
4
With the Allen key loosen the 4 cover screws and remove the terminal board
enclosure cover, see Figures 3. You will see the terminal board inside the actuator.
Remove the ground cable from the cover in the enclosure. The position of the
connections is shown on the yellow label that you will find inside the cover just
removed, see Figure 4.
Removing terminal board enclosure cover
Electrical connections
Installation, Operation and Maintenance Manual
VCIOM-17109-EN Rev. 0
Assembling Procedure