Table of Contents
Advertisement
Section 2: Assembling Procedure
May 2022
•
•
Figure 8
Figure 9
NOTE:
Please note that the design of the Local Interface black connector has been engineered to
allow the installation in one way only. Due to the special design, it is not possible to reverse
the connection of the 4 cables to the terminal board and it is not possible to make a wrong
connection of the connector.
•
6
Now the Local Interface is connected to the actuator, see Figure 8.
Take the 4 screws removed from terminal board cover and use them to fix the Local
Interface to the actuator, using the 5 mm Allen key, see Figure 9.
OM3 kit connected to the SCE300 terminal board
Fixing the local interface onto the SCE300 actuator
The installation of the OM3 Local Interface module onto the SCE300 actuator is
now complete.
Installation, Operation and Maintenance Manual
VCIOM-17109-EN Rev. 0
screws
Assembling Procedure
Advertisement
Table of Contents
