Table of Contents
Advertisement
App Functions
(cont.)
– Miscellaneous
Emergency Power Off
The antenna comes with an emergency power off feature. If you need to stop the Trav'ler Pro
antenna at any time during a Search or Stow sequence, press "Search", or "Stow" again (i.e. repeat
the same command) to stop the antenna. The antenna will stop in its current position and power will
be disconnected from the ODU. Once the antenna has stopped, the ODU will automatically reboot
and wait for the next command. If the emergency power off feature is used, the antenna may not be
in a safe position for travel. Do not move the vehicle until the unit is stowed.
In addition to the Emergency Power Off, you can also perform an Emergency Reset. To do this you
need to press all three buttons (Power, Search, and Stow) at the same time. This will immediately
cycle power to the IDU and force a restart. Once the IDU restarts, it will come to the ready state and
wait for a request.
Emergency Manual Stow
If unable to stow the Trav'ler Pro antenna, it may be necessary to manually stow the antenna in order
to travel. Emergency Manual Stow is meant to be used as a last resort and is not meant for common
usage. To perform the Emergency Manual Stow, make sure the power to the IDU is disconnected.
Once disconnected, proceed to the roof and remove the six Phillips screws and housing from
the turret. Disconnect the motor assembly cable from the motor and three 9/64" Allen screws to
remove the motor from the turret. To lower the antenna, use a 12mm 6-point socket on the elevation
motor's square shaft and turn the shaft clockwise to lower the antenna. Once lowered to the stow
position, reconnect the motor assembly cable prior reinstalling the motor. Once the assembly cable
is connected, be sure the motor coupler is aligned with the shaft. After aligning the motor install the
three 9/64" Allen screws (Torque – 25 in-lbs). Verify the seal of the gasket prior to aligning the plastic
housing over the screw holes, and seat the housing on the gasket. Reinstall the six Phillips screws.
Do not use a drill as you can strip the base.
NOTE: Before lowering the antenna be sure to antenna will stow towards the back of the vehicle.
On the mount base, the transition plate is marked "FRONT" and "BACK." If the antenna is not in a
position to stow towards the back of the vehicle, remove the AZ motor assembly cable from the top
of the motor and rotate the antenna by hand until the antenna is aligned with "BACK" on the transition
plate. Once aligned, reconnected the AZ motor assembly cable and lower the antenna.
Manage Devices
Managing devices can be done from the Device Selection/Add New Device page by pressing the
Menu button (3 bars top left) and selecting Manage Devices under My Tools. The Manage Devices
screen gives you the ability to register a new device, remove a device, and manage authorized users
for devices.
To register a new device, press the green plus sign next to Register New Device at the bottom of the
page. To remove a device, press the trash icon.
Add an authorized user by pressing the green plus sign next to the device. Then select "Add New
User". At this point, you will be asked to enter the person's name, email address, and select if they are
the owner or a guest. Owner access will not expire whereas if you want to give someone temporary
access, set the owner field to "false" and set "expires on" to the desired date. The guest access is
intended to be set up for anyone needing temporary access such as a dealer or mobile technician.
The IDU has the ability to pair five devices to it.
10
Advertisement
Table of Contents
