Panasonic PT-LB10NTU Service Manual page 24

4. Attach the base plate with 4 screws.
5. Tighten the 2 screws temporarily just until new LCD panel (with
the panel attachment and panel adjuster) can be shifted by your
fingers.
6. Reassemble the projector in the reverse order of disassembling,
but leave the upper case and the screws fixing the A-P.C.Board
block as they are removed.
7. Adjust the convergence according to the section 8.4.
"Convergence Adjustment".
8. After the adjustment, while paying attention not to vary the
PDF created with pdfFactory Pro trial version
24
www.pdffactory.com